Under the instrument panel, look under the glove box. On the right side of the fender wall you will find another fuse box.The relay is located in the fuse panel (power distribution box) located in the engine comaprtment. Below is a picture of the location of that panel and a diagram of the fuses and relays. The blower motor relay is the one located in the number 55 position.
Which fuse is the blower motor fuse?
Where is the blower motor fuse located?
Many vehicles have two fuses for the blower motor, one in the interior fuse block and the other under the hood. The blower motor is usually under the dashboard on the passenger side.
What relay controls the blower motor?
The blower motor relay controls the current used to power the blower motor, and is subject to the constant on and off switching.
How do I know if my blower motor fuse is blown?
If you hear that the blower motor is operating but don't feel any air flowing through the vents, the problem is with the airflow controls [source: RepairPal]. If the blower motor isn't running you should: Use voltmeter or ohmmeter to check for a blown fuse.
Which fuse is the blower motor fuse?
Does a blower motor have a relay?
In a blower motor, the relay supplies the power that allows the fans to circulate warmed air. Essentially an on/off switch, the blower motor relay's reactions start and end the heating process in HVAC systems by controlling the flow of current between the power source and the motor.
What can cause a blower motor to stop working?
In most cases, a blower motor resistor fails due to corrosion or overheating. Sometimes, the mechanical resistance to the motor rotation causes an excessive electric current that can overheat and prematurely damage the blower motor resistor.
How do I know if my heater fuse is blown?
You can quickly determine by checking resistance with a multimeter. A good fuse will have nearly zero ohms of resistance, if the fuse is blown there will be no reading.
How do I test a blower motor relay?
Connect a test light or multimeter to the ground (black lead). Turn the ignition key to the on position (engine off), and remove the relay. Using the probe, test all terminal sockets in the relay connector. Two of the four should have power.
How can I tell if a relay is bad?
You want to feel and listen for any clicks. If you feel and hear clicks, the relay works on one side – the side with the energizing circuit and coil. However, if there was no sound from the horn, the relay has a problem along the contact circuit.
What does a blown fan fuse look like?
Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.
What fuse controls the heat in a car?
The blower fuse is a 40 amp fuse located in the engine compartment's fuse box.
What causes heater blower not working?
If little air is coming through the vents (hot or cold), then it could be because the blower motor for the fan or a switch or resistor that controls fan speed isn't working. Another cause might be that the electronically controlled “blend doors” that direct air flow are stuck or broken.
How do I reset my AC blower?
Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.
Where is the fuse for the heater?
Fuses. If your furnace has a fuse, it will probably be located in the control box with the blower. BIf you can't locate it, the transformer may have burned up and will need to be replaced. Once you've located the fuse, check its wires to see if they're broken or look for signs of discoloration or cloudiness.
What causes heater blower not working?
If little air is coming through the vents (hot or cold), then it could be because the blower motor for the fan or a switch or resistor that controls fan speed isn't working. Another cause might be that the electronically controlled “blend doors” that direct air flow are stuck or broken.
What can cause a blower motor to stop working?
In most cases, a blower motor resistor fails due to corrosion or overheating. Sometimes, the mechanical resistance to the motor rotation causes an excessive electric current that can overheat and prematurely damage the blower motor resistor.
Which fuse is the blower motor fuse?
What happens if blower motor relay goes bad?
If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.
Where is the blower motor reset button?
Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.
How do I know if my blower motor resistor is bad or blower motor?
Signs of a Bad Blower Motor Resistor Loss of HVAC fan control (total or certain speeds) The fan only works on its highest speed setting. No air coming from vents. Intermittent or inconsistent fan speed.
Will a blown fuse cause my heater not to work?
Faulty Wiring or Blown Fuses Similar to your broken HVAC controls, your car's wiring could be broken or have a short in it. This would mean the heater isn't triggered when the driver commands it to function.
Where is the fuse for the heater?
Fuses. If your furnace has a fuse, it will probably be located in the control box with the blower. BIf you can't locate it, the transformer may have burned up and will need to be replaced. Once you've located the fuse, check its wires to see if they're broken or look for signs of discoloration or cloudiness.
What happens when blower motor resistor goes out?
If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored.
Where is the blower motor resistor?
The heater blower motor resistor is often found beneath the dashboard. It is located in the heater and air conditioning compartment. It's connected to the air conditioning system, where it can adjust the speed of the blower motor fan. It can also be found behind the glove box of some vehicles.
Why does my blower motor keep blowing fuses?
Thus, blown fuses could be a sign of relay issues. Blower motor relays handle a large amount of current. Malfunctioning relays aren’t able to distribute their load properly.
How does a blower motor relay work?
The blower motor relay does more than channel electrical current. Relays are a vital protection against electrical surges. When the relay receives a jolt of strong current or simply cannot manage and distribute its load, it will send excess current into the fuse. This forces a shutdown which protects the entire system from electrical damage.
Where is the fuse box on a Toyota Corolla?
fuse box location. The junction block is located in the end cover at the left side of the instrumental panel. fuse box layout. type 1. Headlamp Switch, Overhead A/C Control, Instrument Cluster, Radio, Rear Wiper/Defogger Switch, Ash Receiver Lamp & A/C-Heater Control
Where is the fuse box on a Dodge Durango?
Fuse box in passenger compartment Dodge Durango. fuse box location. The junction block is located in the end cover at the left side of the instrumental panel. fuse box layout. type 1. Headlamp Switch, Overhead A/C Control, Instrument Cluster, Radio, Rear Wiper/Defogger Switch, Ash Receiver Lamp & A/C-Heater Control
Below you will find two interesting articles on a similar topic 👇
How many blower motors are in a car?How do I know if my heater fuse is blown?
