• Home
  • Where is the cigarette lighter fuse on a Chevy Cobalt?

Where is the cigarette lighter fuse on a Chevy Cobalt?

Author of the blog (work in a car repair shop)
Ask Q

Where is the cigarette lighter fuse on a Chevy Cobalt?


Which fuse is the cigarette lighter fuse?

Depending on your make and model vehicle, the cigarette lighter—or accessory outlet—fuse may be labeled differently, but many car's designate the lighter fuse as “LTR”, short for lighter, and you can find it in the fuse box under the hood.

How do you check a cigarette lighter fuse?

The easiest is to simply plug in the cigarette lighter if you have it. If the lighter heats up and pops out, then the socket has power. You can also use a test light to check for power, if you have one, or examine the fuse panel to see if the cigarette lighter fuse is blown.

What would cause a cigarette lighter not to work?

If the metal on the fuse looks broken or burned, it will need to be replaced. Buy a new fuse of the same amperage from your dealer or auto parts store and replace the bad fuse. Once installed, try the cigarette lighter again.

What is RDO fuse?

On the fuse panel, located in the right door jam, is a fuse marked "RDO Batt". According to my owners manual, this fuse is for: (1) Radio Receiver box (battery) (2) Radio Control Head (passive) and (3) Keyless Entry Module.

How do you tell if a fuse is blown?

Remove the fuse from its holder. In some cases you may need a small screwdriver to unscrew the fuse holder cap. Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.

Premium Member. It's on passenger side in center console under the HVAC where you checked the fuse.

Where is the OnStar fuse located at?

Pull away the right-side panel. You should see a silver metal box inside, which is the OnStar unit. Pull the panel forward just enough so that it clears the stud located in the back lip of the trunk. After pulling it forward, carefully pull it toward the middle of the trunk, revealing the compartment beneath it.

Can a car cigarette lighter drain the battery?

If your car does not have the accessories power shut off feature then leaving things plugged into your car's cigarette lighter will eventually drain your battery.

How much does it cost to replace cigarette lighter in car?

Car Cigarette Lighter Sockets Replacement from $11 | CarParts.com.

How do you tell if a fuse is blown?

Remove the fuse from its holder. In some cases you may need a small screwdriver to unscrew the fuse holder cap. Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.

How can a bad fuse drain a car battery?

A blown fuse will simply stop a headlight or turn signal from functioning. In some cases, it can lead to an open circuit that draws energy. Other causes could be a malfunctioning fuse, leading to a parasitic drain on the battery (think of a glove box light that won't turn off).

What is CTSY?

Acronym. Definition. CTSY. Churches Together in South Yorkshire (UK)

What is fuse amp?

What is fuse rating? You'll usually find the fuse rating on the side of your fuse, which will be given in amps. Fuse rating is the amount of current needed for the fuse to blow or break. When this happens, it stops the electrical power from flowing through the electrical circuit.

How much does it cost to get a fuse replaced?

How much does it cost to fix a blown fuse in a car?

Cars run on electricity as well as gas, and almost all of it runs through fuses. Learn where they are, how to spot a blown fuse, and how to replace them. It takes about five minutes, costs about $1, and it'll save you the hassle of a trip to the repair shop.

Does OnStar drain your battery?

OnStar must communicate periodically with the vehicles but the system should go into a sleep mode when not being used. If the sleep mode fails to function, then OnStar is enough to pull a battery down over a period of time.

Can OnStar track a stolen car if not activated?

If your car is stolen and you have Onstar, they may be able to track it for you even if your Onstar subscription is not active. Onstar uses GPS technology to track the location of its subscribers' vehicles, so as long as the stolen car has power and is in range of a cellular signal, Onstar should be able to track it.

Can OnStar shut down your car?

Remote Ignition Block: After a member has filed a police report, OnStar can send a remote signal that blocks the vehicle's engine from being restarted once it's turned off.

Do phone chargers drain car batteries?

Charging your phone while on the road could drain your car's battery, too. If you leave your car running on “accessory” — where your engine is off, but you still use the radio — the device will draw power from your car's battery as it charges.

Does leaving your phone charger plugged in ruin your car battery?

Plugging your phone into a car's USB port could stall the charging and even damage the charger. Charging your phone could even drain a car's battery, especially if it's an older model.

What can drain a car battery when the car is off?

What may drain a car battery when it's off are things such as interior lights, door lights, or even bad relays. While your engine runs, the alternator recharges the battery — which is why you typically don't have to worry about the battery dying while you're blasting the radio on your drive to work!

When did they stop putting cigarette lighters in cars?

The ashtray and cigarette lighters were popular in cars from the '50s and '60s and became a staple for the interior for years after that. It wasn't until the '90s that automakers started phasing them out altogether.

Are cigarette lighters in cars universal?

There are a handful of cigarette lighter standards globally, but the one used in the United States is ANSI/SAE J563. Since this standard describes measurements like the diameter of the receptacle, accessory manufacturers can make power plugs that have a relatively snug fit, and spring-loaded contacts take up the slack.

Can a bad fuse drain a car battery?

3. Electrical Glitches. Electrical glitches in your car and car battery may be caused by factors such as poor installation, faulty fuses, and flawed wiring. These electrical glitches can result in the normal and expected parasitic drains on your car battery becoming excessive and drain the battery when the car is off.

Below you will find two interesting articles on a similar topic 👇

Where is the fuse panel located on a 2004 Chevy Silverado?

Can You DIY replace a heater core?

Tired of looking for a video for your question?

Video Answer below 👇

Were our answers helpful?

Yes No

Thanks so much for your feedback!

Have more questions? Submit a request

FAQ for the last Day

  • Is it bad to turn the furnace on and off?
  • Turning your heat or your air conditioning off may not damage your system, but you may experience “collateral damage.” For example, if your house gets cold during the day and the temperatures are low outside, your pipes may freeze and burst.Many homeowners throughout the Maryland and Washington, DC area question if they should turn off their furnaces while they go on vacation. Turning off your fur...


  • What does a blinking light mean on my furnace?
  • Flashing lights could indicate that your thermostat is not sending a signal to the furnace. This problem can be caused by an issue with the wires in your walls, or it might just be that there is a loose wire connection somewhere.How do you fix a blinking red light on a furnace? This could be an indicator your flame sensor is dirty, and cleaning it should fix it. However, this could also mean there...


  • What is the purpose of a blower on a furnace?
  • The blower is one of the most appropriately named components in your furnace: its sole job is to blow hot air through the ducts and into your home.Are the furnace fan and blower the same thing? Most central heating systems in existence today are forced air systems and therefore require air to be moved in some way. A furnace fan, also known as a furnace blower, is one of the easiest ways to accompl...


  • What happens when a furnace filter is clogged?
  • A clogged furnace air filter will negatively affect the airflow throughout your house and HVAC system. The lack of fresh air in your furnace will cause the heat exchanger to become too warm and deactivate. Dirty filters indirectly cause short cycling issues and will make it hard to keep your home warm.When a furnace air filter is heavily clogged, the amount of pressure inside of the furnace change...


  • Will a furnace reset itself?
  • Press and hold the reset button for about 30 seconds. Raise your thermostat to the desired temperature. This should ignite your furnace. If there's no ignition, then it's time to call a professional.How long does it take for a furnace to reset? Press and hold the reset button for about 30 seconds. Raise your thermostat to the desired temperature. This should ignite your furnace. If there's no igni...


  • Why is my furnace blowing out cold air?
  • If your furnace is blowing cold air in your home, this is a sign of an issue with the flame detector, gas supply, air filter, pilot light, or condensate lines. Many of these issues are able to be easily solved on your own by sanitizing or replacing components in the gas furnace.Why is my furnace running but no heat? Dirty filters are the most common cause of furnace problems. Dust and dirt restric...


  • How long does it take for a furnace to start blowing hot air?
  • When the furnace is turned on, everything needs time to fire up. That said, if you're noticing that the heater is blowing cold air, try waiting a little longer. This is especially true if this is the first time the furnace is turned on this season. Your furnace should start blowing warm air within 15 minutes.How long does it take a furnace to kick in? A furnace should take around five minutes to s...


  • What would cause a gas furnace not to ignite?
  • If your gas furnace initiates the start cycle but does not fire up, it's likely because of a faulty, damaged, or dirty ignitor/sensor. This is a very common furnace problem—you can try to clean the sensor and replace the ignitor.How do I get my furnace to ignite? Once the gas has had time to dissipate, turn the knob to "Pilot." Then, hold down the "Reset" button and bring the flame of a long light...


Comments

Leave a Comment

how
Email us